|
|
Strength Instructions –
Dilution Ratio
Light =
1/2 oz of ZM6 added to 1 quart of water. Spray on surface and
wipe clean. Use on mirrors, windows, soils, spills, everyday dirt and
grime.
Medium = 2 oz of ZM6
added to 1 quart of water. Spray on surface, allow to work for 1 minute
and wipe clean. Use on countertops, kitchen, bathroom and
hardwood floors.
HEAVY = 4 oz of ZM6 to 1
quart of water. Spray on surface. Allow solution to work for 1
minute. On very tough or old stains, use stiff brush to loosen
stain and wipe away. Use on tile, grout, stovetops, soap scum,
rust, crayon marks, grills. For tougher stains like tile, grout,
soap scum and set in stains, ZM6 can be used full strength or
diluted.
Use ZM6 full strength for
extremely tough stains.
Easy Steps For Cleaning
Carpet
1. Add
1/2
cup of ZM6 to 1 gallon of clean warm water in a bucket.
2. Agitate the mixture so
you can bring it to a foam.
3. Shake the excess water
off the brush and scoop the thick foam with the end of your
brush. You don’t need to use the water. Excess water
will only saturate the carpet and create mold and mildew.
4. Work the thick foam
into the carpet until clean.
5. Allow carpet to
dry thoroughly.
6. Thoroughly vacuum
carpet.
May also be used in any
commercial machine for cleaning carpeting.
*When spot cleaning, use
in spray bottle. Saturate the stain with cleaner, then wipe until
dry.
Using a small stiff brush
on difficult stains will speed cleaning action.
Note: For best
results vacuum before cleaning.
Special recommendation:
Always test in an
inconspicuous area before using.
Cleaning Instruction
For Upholstery
1. Add 1/2 cup of
ZM6 to 1 gallon of warm water in a clean bucket.
2. Use a thick sponge or
brush to agitate the water to create a thick foam.
3. Squeeze all the excess
water out of the sponge and scoop up the thick foam.
4. Work the foam into the
dirty area or stain.
5. Wipe dry with a clean
white towel.
May also be used in any
commercial machine for cleaning upholstery.
Works on Leather, Vinyl,
Velvet and Valor
Cleaning Instructions For
Bathroom & Kitchen Areas
1. Spray directly onto
surface or apply with sponge. Brush or mop.
2. Allow to work for 1
minute. Using a small stiff brush will speed cleaning action.
3. Rinse with water and
dry with clean towel.
RECOMMENDED USES
∑ Ceramics
∑ Porcelain
∑ Stainless Steel
∑ Fiberglass
∑ Concrete
∑ Copper
∑ Brass
∑ Tile
∑ Grout
Cleaning Instructions
For Garage
Use full
strength: Spray on surface. Allow it to work for 1 to 2 minutes. For
some surfaces, use a stiff brush to loosen grease and oil stains.
|
|
|